Redler devices manufactured by us are used in cereal warehouses, feed mixing plants or mills. The chain conveyor is made entirely of high quality galvanized steel. All elements have been connected with bolted connections (this facilitates assembly and disassembly as well as inspection and service). Depending on the model specification, conveyors have the following capacities:

- PZ100 from 60 to 120 t / h

The modular design of the varied gradual length of the pipes ensures proper selection to the desired length of the device (standard up to 16 m, longer redlers are made to special order). The Redler bottom has been lined along the entire length with non-abrasive PE-UHMW material, which significantly increases and extends the life of the device, reduces damage to transported grain, reduces noise and power consumption. Rollers on the chain return and chain slip plates were also made of hard-wearing PE-UHMW material, which results in greater durability and lower power consumption.

Our devices have warning stickers, instructions, destination certificates, production approval certificates, compliance with standards. Additionally, it is possible to equip the device with:

• - motion sensor,
• - overflow sensor,

electrical protection with cabling Chain conveyors offered by AG-PROJEKT are characterized by:

Model PZS

Drive

Geared Motors

outlet opening PZS

The PZS outlet is adapted to the device model and process line.

A moisture measurement sensor is located in the PZS outlet.

PZS humidity sensor

The built-in humidity sensor in the discharge opening ensures continuous measurement of grain moisture.

A moisture sensor is optional.

1

2

2

Drive shaft with bearings

• 1. Drive shaft
• 2. Shaft bearings

Chain guide roller

The guide rollers are located just under the covers of the PZS conveyor. They hold the chain in the correct upper position.

1

Chain

PE-UHMW plates are bolted to the chain elements (scrapers).

Zasyp przenośnika PZS

PZS conveyor charge

Final drive

End drive with bearings

Pulling station

There is a chain tension adjustment in the reverse station.

Overflow flap

Lack of material reception from the PZS conveyor during operation causes the device flap to be lifted and the limit switch to open.
This state of affairs will turn off the electrical circuit and devices preceding the technological line.
This is standard equipment, other safeguards are optional.

The flap is located at the front of the PZS head

PE-UHMW

Hard-wearing PE-UHMW. The use of wear-resistant plastic extends the service life of the PZS conveyor troughs. Very good sliding properties reduce electricity consumption.
PE-UHMW

Feet PZS

1

2

Inductive sensor of the chain

• 1. moving parts - rotation sensor
• 2. Inductive Sensor

The PZS conveyor uses an induction sensor responsible for transmitting information about the device's operation. Breaking or blocking the chain will disconnect the power supply. The sensor reacts to the moving parts of the drive mechanism

Our devices have all necessary certificates allowing the product to work in accordance with the standards. Offered conveyor capacities t / h.

We encourage you to contact us by phone or e-mail regarding reception baskets. We provide advice in the selection and configuration of an assortment. Our experts will explain all technical issues related to AG-PROJEKT products.